ID |
Product |
Questions/Issues/Solutions |
Category |
Notes |
| 33 |
HT-3826 Battleship |
Poor operation |
Boat |
|
| |
Cause: |
1. If the battery is low.
2. If use the unsuitable battery.
3. If the antenna not pull out enough |
| |
Solution: |
1.Charge the battery
2. Change the battery
3. Pull out the antenna |
| 32 |
HT-3826 Battleship |
Can not fully charge the battery |
Boat |
|
| |
Cause: |
1. If the charge or battery was damaged
2. If the charge socket was damage or loose connection.
3. If the anode and cathode contacted wrong direction. |
| |
Solution: |
1.Replace the battery or charger
2. Ensure the connection is right.
3. Ensure the direction is corrected |
| 31 |
RC B52 Bomber |
The plane's head couldn't go up. |
Airplane |
|
| |
Cause: |
The battery is not in belly weight. |
| |
Solution: |
Readjust the battery position will solve this problem! |
| 30 |
Racing Buggy |
Running too slow or too short |
Car |
|
| |
Cause: |
1.Battery weak in the RC car
2.Motor in the RC car is over heated
3.Dust is entangled in axle shafts
|
| |
Solution: |
1. Charge battery
2. Waiting for a while to cool down the motor then try again
3. Clean the axle shaft
|
| 29 |
Racing Buggy |
Lost control |
Car |
|
| |
Cause: |
1.Transmitter switch is not on position.
2.Battery in transmitter is weak..
3.Battery in RC car is weak.
4. The Transmitter antenna is not extended
5.Transmitter and the receiver in the RC car are different frequencies.
6.Radio signals is conflict with other devices.
|
| |
Solution: |
1. Turn the transmitter switch on
2. Change the battery in transmitter
3. Charge the battery in the RC car
4. Extend the transmitter antenna
5. Use the same frequency for transmitter and RC Car
6. Change location or wait few minute s then try again
|
| 28 |
Racing Buggy |
Car doesn't move |
Car |
|
| |
Cause: |
1.Transmitter or car switch does not turn on
2.No Battery in the transmitter or RC Car
3.Battery installation is incorrect.
4. Weak battery in transmitter.
5. The battery in the RC Car is weak.
|
| |
Solution: |
1.Turn switch on
2.Install battery
3. Reinstall Battery
4.Change the battery
5. Charge battery
|
| 27 |
Apache X-3 |
The tail wing shaking when the helicopter is in the air. |
Helicopter |
|
| |
Cause: |
Control signal issues |
| |
Solution: |
Please use the trimmer key-press of transmitter to adjust the tail wing.
Turn left the trimmer key-press, the plane will turn according to clockwise,
turn right the trimmer key-press, the helicopter will spin counter clockwise.
When the trimmer key-press is not able to level off the tail wing. you should
open a piece of rubber that under the power switch of the transmitter
controller. By adjusting the center nub, you can gain more control on the
tail wing. |
| 26 |
Apache X-3 |
When the helicopter takes off, it appears turnning |
Helicopter |
|
| |
Cause: |
Fixed wreath may be loose |
| |
Solution: |
Please press down the the fixed wreath |
| 25 |
Apache X-3 |
When the helicopter takes off, it appears turnning |
Helicopter |
|
| |
Cause: |
Airscrew may be loose |
| |
Solution: |
Please press down the the fixed wreath |
| 24 |
Apache X-3 |
Helicopter always goes off course |
Helicopter |
|
| |
Cause: |
Unbalance power output |
| |
Solution: |
Adjust the right side trimming tab on the transmitter |
| 23 |
Combat Forace |
Helicopter spirals counter clockwise or keeps turning counter clockwise in air |
Helicopter |
|
| |
Cause: |
Unbalanced power given |
| |
Solution: |
Push and release the right side of the trim BUTTON on transmitter repeatedly until the turning stop and helicopter can fly straight. |
| 22 |
Combat Forace |
Helicopter spirals clockwise or keeps turning clockwise in air |
Helicopter |
|
| |
Cause: |
Unbalanced power output |
| |
Solution: |
Push and release the left side of the trim BUTTON on transmitter repeatedly until the turning stop and helicopter can fly straight. |
| 21 |
Combat Force |
Helicopter won't take off, spinning on the floor |
Helicopter |
|
| |
Cause: |
Battery is weak! |
| |
Solution: |
Recharge the battery |
| 20 |
Combat Force |
Helicopter out of control |
Helicopter |
|
| |
Cause: |
1. Infrared channel interference with the other device
2. Affected by strong lighting
|
| |
Solution: |
1. Change flying area
2. Change flying area to avoid direct lightings |
| 19 |
Combat Force |
Helicopter don't response |
Helicopter |
|
| |
Cause: |
The channel selection on transmitter is incorrect |
| |
Solution: |
Reset to correct channel |
